2020-03-31 15:19:42 +0200 | asked a question | sage-shell-mode sending code region to sage-shell only loads file New to both python and sage. I have installed sage-shell-mode in emacs. I tested M-x run-sage, and it starts a shell. I created a test.sage file with three lines I send the code (either by C-c C-c, or first marking a region and then C-c C-r) to the sage shell. It only loads a file, as in I expected it to show the results. I am using emacs 26.3 and sage 8.1 on Ubuntu 18.4. I have no special configuration in init.el other than Thank you for help. |

Copyright Sage, 2010. Some rights reserved under creative commons license. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.